Alamo SR14 Manuale Utente Scaricare il pdf (Pagina 146)

MAINTENANCE

SR20M/SR14M 04/94 Maintenance Section 5-16

STEP 3

Remove the Hub Assembly from the vise and place it on a solid surface with the Gear in an upright position. Using

a Hammer, tap this Gear downward until the Adjusting Nuts fully exposed. Remove the Cotter Pin. Remove the

Adjusting Nut. FIGURE 28.

STEP 4

Laying the Hub Assembly on its side, tap the Gear end of the Output Shaft into the Gear and Bearing. Once the

Shaft has cleared the Bearing, it can be fully removed from the Hub Assembly. The remaining Bearings and

Bearing Cups can be removed by conventional means. FIGURE 29.

FIGURE 28

FIGURE 29

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 165 166

Nessun commento

Alamo SR14 Manuale Utente Pagina 146